Installation Guide - VI. One

INSTALLING

The installation of VI.ONE is two separate steps: the installation of the Kontakt engine, and the installation of the VI.ONE library.

Insert the installation disc into your computer, and you will see the installers for both components. It doesn’t matter which is installed first. Run each of the installers and they will guide you through the installation process.

The Kontakt installer will install the Kontakt engine, its standalone application, all of its plug-in versions, and the Service Center authorizer program. We recommend theEasy Install and that the install locations for each component are left at their default settings.

The VI.ONE library is approximately 21GB in size, and its installer will prompt you for the location you wish to install it. It can be installed on any available hard drive. For speed reasons, we recommend it be installed on internal or eSATA drives. Firewire can also be acceptable. External USB drives may give somewhat less optimized performance. We also recommend 7200 or 10,000rpm drives regardless of the interface used.


UPDATING

After installation, please make sure that you are fully updated to the most recent versions of the three components that make up the VI.ONE package: the library (which contains all the patch information and programming), the engine (which is powered by Kontakt), and the authorizer (Service Center). It is possible that any of these components may have a more recent version than shipped in your physical package, so you should check for updates to each of these three. You can do this by visiting the vir2.com web site and checking theSupport area.


AUTHORIZING

After you’ve completed installation, VI.ONE will be working in demo mode, meaning it will only work for 30minutes at a time. To fully authorize it, launch Service Center (found in the Applications folder on a Mac, or theProgram Files folder on Windows) and follow its instructions. You will be prompted to enter your e-mail address and password that make up your NativeInstruments account, or will be given an option to create an account if you don’t already have one. Once inside theService Center, it will give you a list of all the NativeInstruments and NI-powered products on your hard drive and give you the option to activate them. You are allowed to install and use VI.ONE on up to two computers simultaneously.

Service Center will guide you through the process for either online (instant) activation, or offline activation if the computer you installed VI.ONE on does not have direct access to the internet.